Preparing Your Water Filtration System for Freezing Temperatures

Preparing Your Water Filtration System for Freezing Temperatures

McTavish Jones |

When colder weather arrives, protecting your water filtration system belongs on the same checklist as disconnecting garden hoses and preparing outdoor faucets. Water left inside plumbing and filter housings can freeze and expand, potentially damaging components and causing leaks when temperatures rise again.

Whether your Cascadian system serves your everyday home or a seasonal cabin, a little preparation now can help prevent an unexpected repair later.

Check the temperature where your system is installed

A warm living room does not necessarily mean your filtration system is protected. Garages, crawl spaces, pump houses, and outdoor enclosures can get much colder than the rest of your home.

Cascadian’s ICS installation guide requires a location protected from freezing. For reference, the ICS-TP specification lists a minimum operating temperature of 39.2°F. Check the specifications for your particular model and plan protection before temperatures reach its lower limit.

Consider placing a thermometer near the system so you can monitor the conditions it actually experiences.

Protect the system and surrounding plumbing

For a system that will stay in use throughout winter, maintaining a reliably warm installation space is essential. Inspect nearby doors and access panels for drafts, and insulate exposed supply pipes where appropriate.

Insulation slows heat loss, but it does not generate heat. A wrapped housing or insulated enclosure should not be treated as a guarantee against freezing during prolonged cold or a power outage. Ask your installer about suitable protection if your system sits in an unheated area.

Avoid applying heating devices directly to filter housings unless the equipment manufacturer specifically approves that use.

Leaving for winter? Plan a complete shutdown

Closing up a cabin or leaving a home unheated requires a different approach from preparing an occupied house.

Turning off the water or opening a bypass does not automatically empty the filter housings. Based on the ICS manual’s separate isolation, pressure-relief, and draining steps, water can remain inside until it is deliberately drained.

Have your plumber include the filtration system, connected piping, valves, and any other treatment equipment in the home’s winterization plan. Follow the instructions for your specific equipment, and ask Cascadian about cartridge handling and storage before a seasonal shutdown.

Never loosen a filter housing while it is pressurized. Do not assume that opening a drain removes every pocket of water or makes a wet cartridge safe to freeze.

If you are keeping the home heated while away, Washington Water’s winter guidance recommends a thermostat setting of at least 55°F. Still check the temperature around the filtration system, and arrange for someone to check the home during cold spells.

Know what to do if freezing is suspected

A sudden loss of flow during freezing weather deserves attention. If you suspect your filtration system has frozen, stop using it and contact your plumber or Cascadian before returning it to service.

If a leak develops, shut off the water supply when safe to do so. Never use an open flame to thaw plumbing. Have potentially damaged equipment assessed before repressurizing it; thawing alone does not establish that it is ready for use.

Prepare before the first freeze

Start by checking your installation location, reviewing your system’s temperature limits, and locating your water shutoff.

Not sure how to prepare your Cascadian system for winter? Contact our team with your system model and a photo of the installation. We can help you identify the appropriate next steps for your setup.

Leave a comment

Please note: comments must be approved before they are published.